TV Mounting in Baulkham Hills

Yes if done properly, but check two things: heat (run the fireplace for 30 minutes and confirm the wall above stays below about 40C / 100F, or fit a mantel to deflect heat) and viewing angle (a pull-down or tilting mount stops neck strain). Above-fireplace installs cost more because the wall is usually brick or stone and cable routing is harder.

A professional installer should carry public liability insurance that covers wall damage and a dropped or fallen TV. Ask for proof before booking, and ask whether they guarantee their fixings (many offer 12 months or lifetime on workmanship). Keep the receipt — home insurance claims for fallen TVs often hinge on showing it was professionally installed.

Small TVs (under about 40 inches) can go on hollow drywall with heavy-duty toggle anchors rated for the load, but most professionals prefer to hit at least one stud or install a plywood backing board. For TVs over 50 inches, mounting into studs or masonry is strongly recommended — anchor-only installs on hollow walls are the most common cause of fallen TVs.

Most will, as a small add-on — typically a quarter to half the price of a fresh install. Dismount-and-remount in a new home (or after moving the sofa) is a standard job; mention it when booking so the installer brings patching filler for the old holes.

Either works. Buying your own mount is usually cheaper — check it matches your TV's VESA pattern (the four bolt holes on the back, e.g. 400x400) and its rated weight. Many installers also sell mounts on the day at a markup of roughly 20-50% over retail. If you buy your own, tell the installer the model so they bring the right fixings.

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

No. Unlike the US or UK, Australia prohibits all DIY fixed wiring — a new power point must be installed by a licensed electrician, who will supply a certificate of compliance. Most TV installers either partner with a sparky or route an existing outlet's leads through in-wall rated cable management instead.

Usually yes, by roughly 20-50%. Much of Australia's older housing stock (especially WA and older east-coast suburbs) is double brick, which needs a hammer drill and masonry anchors, and in-wall cable concealment is generally not possible — installers use paintable surface duct instead.