TV Mounting in Yishun New Town

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

Yes — brick and concrete are actually stronger than drywall for mounting. The installer uses a hammer drill and masonry anchors (sleeve or wedge anchors). It costs more than a stud wall because drilling is slower and cable concealment usually has to run in surface trunking rather than inside the wall.

Most TV mounting jobs are priced as a flat rate per TV, driven by three things: TV size, mount type (fixed, tilting, or full-motion), and wall material. Drywall or plasterboard with timber studs is the cheapest; brick, concrete, or above-fireplace installs cost more. Cable concealment is usually a separate add-on. Ask for the all-in price for your exact TV size and wall type before booking.

A professional installer should carry public liability insurance that covers wall damage and a dropped or fallen TV. Ask for proof before booking, and ask whether they guarantee their fixings (many offer 12 months or lifetime on workmanship). Keep the receipt — home insurance claims for fallen TVs often hinge on showing it was professionally installed.

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

Either works. Buying your own mount is usually cheaper — check it matches your TV's VESA pattern (the four bolt holes on the back, e.g. 400x400) and its rated weight. Many installers also sell mounts on the day at a markup of roughly 20-50% over retail. If you buy your own, tell the installer the model so they bring the right fixings.

Most walls yes, but not structural columns, beams, or reinforced-concrete walls (commonly the wall around the bomb shelter/store room). Drilling into structural members breaches HDB renovation rules. An experienced installer identifies safe walls on sight; partition walls in newer BTO flats may be drywall panels needing special anchors.

Because HDB and most condo walls are solid concrete — there is no cavity to drop cables into. Installers instead use slim paintable PVC trunking, typically included or a small add-on. True concealed wiring requires hacking a channel into concrete, which is a renovation-scale job requiring an HDB permit for certain walls.