TV Mounting in Yew Tee

Search for handymen or dedicated TV installers in Yew Tee with recent reviews that mention your wall type (drywall, brick, or concrete). Ask three things up front: the flat price for your TV size and wall type, whether they carry liability insurance, and whether cable concealment is included or an add-on. A good installer asks about your wall and TV model before quoting.

A standard install on a stud or masonry wall takes 30-90 minutes. Add 1-2 hours if cables are being concealed inside the wall, and more again for above-fireplace installs or walls that need reinforcement. Book a 2-hour window to be safe.

Yes if done properly, but check two things: heat (run the fireplace for 30 minutes and confirm the wall above stays below about 40C / 100F, or fit a mantel to deflect heat) and viewing angle (a pull-down or tilting mount stops neck strain). Above-fireplace installs cost more because the wall is usually brick or stone and cable routing is harder.

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

Yes, and it is cheaper to bundle than to book twice. Soundbar brackets attach either to the wall below the TV or to the TV mount itself. Consoles and set-top boxes go on a small floating shelf or behind-TV bracket. Expect a modest add-on charge per extra device, plus cable management for each.

Most walls yes, but not structural columns, beams, or reinforced-concrete walls (commonly the wall around the bomb shelter/store room). Drilling into structural members breaches HDB renovation rules. An experienced installer identifies safe walls on sight; partition walls in newer BTO flats may be drywall panels needing special anchors.

Because HDB and most condo walls are solid concrete — there is no cavity to drop cables into. Installers instead use slim paintable PVC trunking, typically included or a small add-on. True concealed wiring requires hacking a channel into concrete, which is a renovation-scale job requiring an HDB permit for certain walls.