TV Mounting in Epping

Yes if done properly, but check two things: heat (run the fireplace for 30 minutes and confirm the wall above stays below about 40C / 100F, or fit a mantel to deflect heat) and viewing angle (a pull-down or tilting mount stops neck strain). Above-fireplace installs cost more because the wall is usually brick or stone and cable routing is harder.

Search for handymen or dedicated TV installers in Epping with recent reviews that mention your wall type (drywall, brick, or concrete). Ask three things up front: the flat price for your TV size and wall type, whether they carry liability insurance, and whether cable concealment is included or an add-on. A good installer asks about your wall and TV model before quoting.

Usually only with the landlord's written permission, since mounting leaves 4-6 anchor holes. Many tenancy agreements class it as an alteration. Alternatives that need no drilling: a TV floor stand, or a heavy-duty easel-style mount. If you do get permission, keep the mount and ask the installer to patch holes when you move out — it is a quick filler-and-paint job.

Small TVs (under about 40 inches) can go on hollow drywall with heavy-duty toggle anchors rated for the load, but most professionals prefer to hit at least one stud or install a plywood backing board. For TVs over 50 inches, mounting into studs or masonry is strongly recommended — anchor-only installs on hollow walls are the most common cause of fallen TVs.

No. Unlike the US or UK, Australia prohibits all DIY fixed wiring — a new power point must be installed by a licensed electrician, who will supply a certificate of compliance. Most TV installers either partner with a sparky or route an existing outlet's leads through in-wall rated cable management instead.

Usually yes, by roughly 20-50%. Much of Australia's older housing stock (especially WA and older east-coast suburbs) is double brick, which needs a hammer drill and masonry anchors, and in-wall cable concealment is generally not possible — installers use paintable surface duct instead.