TV Mounting in Cairns

Not for the mounting itself. You need one only if you want a new power outlet behind the TV, since fixed wiring is electrician-only work in most countries. Many TV mounting companies partner with an electrician or offer the outlet as an add-on — ask when booking so it happens in one visit.

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

Fixed mounts sit flattest against the wall and are cheapest. Tilting mounts angle down 5-15 degrees — useful when the TV sits above eye level. Full-motion (articulating) mounts extend and swivel, which suits corner installs or rooms with multiple viewing positions; they cost the most and need the most secure fixing because the load hangs away from the wall.

Yes — brick and concrete are actually stronger than drywall for mounting. The installer uses a hammer drill and masonry anchors (sleeve or wedge anchors). It costs more than a stud wall because drilling is slower and cable concealment usually has to run in surface trunking rather than inside the wall.

No. Unlike the US or UK, Australia prohibits all DIY fixed wiring — a new power point must be installed by a licensed electrician, who will supply a certificate of compliance. Most TV installers either partner with a sparky or route an existing outlet's leads through in-wall rated cable management instead.

Usually yes, by roughly 20-50%. Much of Australia's older housing stock (especially WA and older east-coast suburbs) is double brick, which needs a hammer drill and masonry anchors, and in-wall cable concealment is generally not possible — installers use paintable surface duct instead.