TV Mounting in Adelaide Hills

Small TVs (under about 40 inches) can go on hollow drywall with heavy-duty toggle anchors rated for the load, but most professionals prefer to hit at least one stud or install a plywood backing board. For TVs over 50 inches, mounting into studs or masonry is strongly recommended — anchor-only installs on hollow walls are the most common cause of fallen TVs.

Either works. Buying your own mount is usually cheaper — check it matches your TV's VESA pattern (the four bolt holes on the back, e.g. 400x400) and its rated weight. Many installers also sell mounts on the day at a markup of roughly 20-50% over retail. If you buy your own, tell the installer the model so they bring the right fixings.

A standard install on a stud or masonry wall takes 30-90 minutes. Add 1-2 hours if cables are being concealed inside the wall, and more again for above-fireplace installs or walls that need reinforcement. Book a 2-hour window to be safe.

Most TV mounting jobs are priced as a flat rate per TV, driven by three things: TV size, mount type (fixed, tilting, or full-motion), and wall material. Drywall or plasterboard with timber studs is the cheapest; brick, concrete, or above-fireplace installs cost more. Cable concealment is usually a separate add-on. Ask for the all-in price for your exact TV size and wall type before booking.

Get the quote itemised: mounting labour, the mount itself (if supplied), cable concealment, and any electrical work. Quotes in Adelaide Hills that look unusually cheap often exclude the mount or charge extra on arrival for masonry walls. A fair comparison is the all-in price for your exact TV size, wall type, and cable finish.

No. Unlike the US or UK, Australia prohibits all DIY fixed wiring — a new power point must be installed by a licensed electrician, who will supply a certificate of compliance. Most TV installers either partner with a sparky or route an existing outlet's leads through in-wall rated cable management instead.

Usually yes, by roughly 20-50%. Much of Australia's older housing stock (especially WA and older east-coast suburbs) is double brick, which needs a hammer drill and masonry anchors, and in-wall cable concealment is generally not possible — installers use paintable surface duct instead.