Aircon Servicing & Repair in Rustenburg

A chemical wash uses a cleaning solution to strip dirt and mould from the evaporator coil, blower wheel, and drain pan without dismantling the whole unit. Book one when a normal service no longer fixes weak airflow, bad smells, or water leaking from the indoor unit — typically every 12-18 months for heavily used units.

A standard service covers cleaning or replacing filters, cleaning the evaporator coil and blower, flushing the drainage tray and pipe, checking refrigerant pressure, testing thermostat and controls, and inspecting electrical connections. It does not include repairs, parts, or refrigerant top-ups — those are quoted separately.

Once a year is the minimum for a system used seasonally; every 3-4 months if you run it daily in a hot climate. Regular servicing keeps coils and filters clean, which protects the compressor — the most expensive part to replace — and keeps energy use down.

Inverter units vary compressor speed instead of switching on and off, so they hold temperature more steadily and cost 20-40% less to run for long daily use. Non-inverter units are cheaper upfront and fine for rooms cooled a few hours a day. For daily whole-day use, the inverter premium usually pays back in 2-3 years.

A unit that trips the breaker at startup usually has a failing compressor, a shorted capacitor, or a wiring fault — all electrical faults that need a technician. Do not keep resetting the breaker; repeated tripping can damage the compressor beyond repair.

Most charge a call-out or diagnostic fee that covers travel and the first inspection; many waive or credit it against the repair if you go ahead. Confirm the fee, whether it is credited, and any surcharge for evenings, weekends, or urgent same-day visits before the technician is dispatched.

A standard service on a midwall split runs R550-R950 per unit, and a regas (only after leak repair) R900-R1,800 depending on gas type. Metro rates (Joburg, Cape Town, Durban) are at the upper end; add a call-out fee of R300-R500 outside central areas.

Repeated hard power cuts and surges are a leading cause of failed compressors and PCBs. A surge protector or delay-start relay (R500-R1,500 installed) is cheap insurance; many technicians fit one during a routine service.