Aircon Servicing & Repair in Gqeberha

A musty smell means mould or bacteria on the evaporator coil or in the drain pan — fixed with a chemical wash. A burning smell can be dust on a heater element or a failing motor and is worth an inspection. A vinegar-like or chemical smell can indicate a refrigerant leak; turn the unit off and call a technician.

Pricing depends on the service depth: a basic clean-and-check per unit is the cheapest, a chemical wash costs roughly double, and a full overhaul double again. Multi-unit discounts are standard. Get the per-unit rate and what is included in writing before booking — see the national price ranges on this page as a baseline.

Once a year is the minimum for a system used seasonally; every 3-4 months if you run it daily in a hot climate. Regular servicing keeps coils and filters clean, which protects the compressor — the most expensive part to replace — and keeps energy use down.

A standard clean-and-check takes 30-45 minutes per indoor unit. A chemical wash takes about an hour per unit, and a full chemical overhaul (where the unit is dismantled) takes 1.5-2 hours per unit. Multi-unit visits are faster per unit.

You can safely wash or replace filters monthly, keep the outdoor unit clear of leaves and debris, and wipe the indoor casing. Anything involving the refrigerant circuit, electrical components, or coil chemicals should be left to a certified technician — refrigerant handling is legally restricted in most countries.

Most charge a call-out or diagnostic fee that covers travel and the first inspection; many waive or credit it against the repair if you go ahead. Confirm the fee, whether it is credited, and any surcharge for evenings, weekends, or urgent same-day visits before the technician is dispatched.

A standard service on a midwall split runs R550-R950 per unit, and a regas (only after leak repair) R900-R1,800 depending on gas type. Metro rates (Joburg, Cape Town, Durban) are at the upper end; add a call-out fee of R300-R500 outside central areas.

Repeated hard power cuts and surges are a leading cause of failed compressors and PCBs. A surge protector or delay-start relay (R500-R1,500 installed) is cheap insurance; many technicians fit one during a routine service.