Water Heater Installation & Repair in Maryland

A leaking tank can fail suddenly and flood, and any leak near electrics is hazardous. Shut off the unit's power (or gas) and its cold-water feed valve, then call a professional. A dripping pressure-relief valve specifically signals over-pressure or over-temperature — don't cap it.

Yes: annual or biennial sediment flush, anode rod check every 2-3 years in hard-water areas, and TPR (pressure relief) valve testing. Tankless units need periodic descaling. Maintenance is the difference between an 8-year and a 15-year unit.

Rule of thumb for storage: 30-40L per person per day of heated storage for typical use — a family of four lands around 150-200L (40-50 gal). For tankless, size by simultaneous outlets and the temperature rise your groundwater requires; your installer should calculate, not guess.

Usually sediment buildup eating tank capacity, a failed lower heating element, or a broken dip tube mixing cold into the draw. All are diagnosable in one visit; sediment flushing and element swaps are routine repairs on a healthy tank.

Like-for-like tank swaps take 2-4 hours. Fuel-type changes, relocations, tankless conversions, or units needing new circuits/venting run half a day to a full day plus possible permit inspections.

Frequently yes — many utilities and state programs offer hundreds of dollars off ENERGY STAR heat pump water heaters, and income-qualified electrification rebates exist in many states. Check your utility's marketplace before buying a standard electric tank; the running-cost gap is large.