TV Mounting in Vallejo

A standard install on a stud or masonry wall takes 30-90 minutes. Add 1-2 hours if cables are being concealed inside the wall, and more again for above-fireplace installs or walls that need reinforcement. Book a 2-hour window to be safe.

Most will, as a small add-on — typically a quarter to half the price of a fresh install. Dismount-and-remount in a new home (or after moving the sofa) is a standard job; mention it when booking so the installer brings patching filler for the old holes.

Yes if done properly, but check two things: heat (run the fireplace for 30 minutes and confirm the wall above stays below about 40C / 100F, or fit a mantel to deflect heat) and viewing angle (a pull-down or tilting mount stops neck strain). Above-fireplace installs cost more because the wall is usually brick or stone and cable routing is harder.

Under 43 inches is a reasonable DIY job if you can find studs and use a level. From 55 inches up, a second pair of hands is essential and mistakes get expensive — a 65-inch panel weighs 20-25 kg and modern bezel-less screens crack easily if gripped wrong. Professionals also carry stud finders, cable detectors, and masonry drills most households lack.

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

No permit is needed for the mounting or for running low-voltage cables in the wall cavity. A permit and/or licensed electrician is typically required only if you add a new power receptacle behind the TV. Many installers bundle a code-compliant power relocation kit instead, which avoids the permit.

In-wall concealment on drywall typically adds $100-$300 on top of the base mount price, and $150-$500 if a code-compliant power relocation kit or new outlet is included. On brick or stone, expect surface raceway (paintable trunking) instead, usually $50-$150.