TV Mounting in Chico

A standard install on a stud or masonry wall takes 30-90 minutes. Add 1-2 hours if cables are being concealed inside the wall, and more again for above-fireplace installs or walls that need reinforcement. Book a 2-hour window to be safe.

Yes if done properly, but check two things: heat (run the fireplace for 30 minutes and confirm the wall above stays below about 40C / 100F, or fit a mantel to deflect heat) and viewing angle (a pull-down or tilting mount stops neck strain). Above-fireplace installs cost more because the wall is usually brick or stone and cable routing is harder.

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

Yes, and it is cheaper to bundle than to book twice. Soundbar brackets attach either to the wall below the TV or to the TV mount itself. Consoles and set-top boxes go on a small floating shelf or behind-TV bracket. Expect a modest add-on charge per extra device, plus cable management for each.

Get the quote itemised: mounting labour, the mount itself (if supplied), cable concealment, and any electrical work. Quotes in Chico that look unusually cheap often exclude the mount or charge extra on arrival for masonry walls. A fair comparison is the all-in price for your exact TV size, wall type, and cable finish.

No permit is needed for the mounting or for running low-voltage cables in the wall cavity. A permit and/or licensed electrician is typically required only if you add a new power receptacle behind the TV. Many installers bundle a code-compliant power relocation kit instead, which avoids the permit.

In-wall concealment on drywall typically adds $100-$300 on top of the base mount price, and $150-$500 if a code-compliant power relocation kit or new outlet is included. On brick or stone, expect surface raceway (paintable trunking) instead, usually $50-$150.