TV Mounting in Weston-super-Mare

Small TVs (under about 40 inches) can go on hollow drywall with heavy-duty toggle anchors rated for the load, but most professionals prefer to hit at least one stud or install a plywood backing board. For TVs over 50 inches, mounting into studs or masonry is strongly recommended — anchor-only installs on hollow walls are the most common cause of fallen TVs.

Usually only with the landlord's written permission, since mounting leaves 4-6 anchor holes. Many tenancy agreements class it as an alteration. Alternatives that need no drilling: a TV floor stand, or a heavy-duty easel-style mount. If you do get permission, keep the mount and ask the installer to patch holes when you move out — it is a quick filler-and-paint job.

Search for handymen or dedicated TV installers in Weston-super-Mare with recent reviews that mention your wall type (drywall, brick, or concrete). Ask three things up front: the flat price for your TV size and wall type, whether they carry liability insurance, and whether cable concealment is included or an add-on. A good installer asks about your wall and TV model before quoting.

Yes if done properly, but check two things: heat (run the fireplace for 30 minutes and confirm the wall above stays below about 40C / 100F, or fit a mantel to deflect heat) and viewing angle (a pull-down or tilting mount stops neck strain). Above-fireplace installs cost more because the wall is usually brick or stone and cable routing is harder.

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

Yes — dot-and-dab (plasterboard glued over brick or block, common in post-1980s UK homes) needs special fixings such as corefix bolts that pass through the board into the masonry behind. Standard plasterboard anchors alone are not safe for TVs over about 40 inches on these walls, so tell the installer if your wall sounds hollow but feels solid behind.

No. Hiding aerial and HDMI cables in the wall or in trunking is not notifiable work. Part P applies only if you add a new socket, fused spur, or extend a circuit behind the TV — that part must be done by a registered electrician (NICEIC/NAPIT) or notified to building control.