Electrician in Whanganui

Socket or switch replacement: 30 minutes. New light fixture: 30-60 minutes. New circuit to an appliance: 2-4 hours. Consumer unit/panel upgrade: half a day to a day. EV charger install: half a day. Full rewire of a 3-bedroom home: 3-10 days. Anything involving certification adds paperwork time — ask for the certificate before final payment.

Burning smells from outlets or the panel, sparking, buzzing from the consumer unit, repeated breaker trips you can't isolate, and any exposed live wiring — switch off the affected circuit (or the main switch) and call an emergency electrician. A single dead outlet or a tripped breaker that resets and holds is a next-business-day job at standard rates.

A home EV charger install is typically half a day's work: mounting the unit, running a dedicated circuit from the panel, and adding protection devices. Total cost depends on the charger you buy, cable run distance, and whether your panel has spare capacity — a panel upgrade can double the project. In several countries this is notifiable/regulated work, and grants or utility rebates may apply — ask the installer.

Rewiring is priced per circuit or per property size and is one of the most invasive electrical jobs — walls are opened, and the house may be partly without power for days. Expect a multi-day job costing two to three orders of magnitude more than a service call. Get itemised quotes (per room or per point), and ask what wall-repair 'making good' is included, as that is where quotes diverge most.

Electricians charge an hourly rate plus, often, a call-out or service fee covering travel and the first period on site. Small jobs (replace a socket, install a light fixture) are usually a minimum-charge visit; bigger jobs like panel upgrades or rewiring are quoted fixed. Batch small jobs into one visit — the minimum charge dominates the cost of single small tasks.

Hourly rates typically run $80-$130 plus a call-out/vehicle charge of $50-$100. Auckland and Wellington sit at the top of the range. Emergency after-hours work runs roughly 1.5-2x standard rates.

A narrow band of DIY is legal in your own home — like-for-like replacement of switches, sockets, and light fittings on existing low-risk circuits — but new circuits, switchboard work, and anything in damp areas requires a registered electrician, and prescribed work needs certification. When selling, uncertified work becomes your problem.