Drywall Installation & Repair in Auckland

If board has swollen, sagged, or grown mould it must be cut out and replaced — drying alone is not enough. Fix the leak first, cut back at least 30 cm beyond visible damage, and let the cavity dry before new board goes in. Persistent damp needs a moisture-meter check.

Drywall (plasterboard) repair replaces or patches board sheets and finishes the joints with tape and compound. Traditional plastering applies wet plaster coats over masonry or lath. Older homes often have solid plaster walls that need a plasterer, not a drywall contractor.

Hairline cracks at joints and above door frames are usually seasonal movement and are cosmetic. Wide (over 3 mm), diagonal, or recurring cracks, or cracks paired with sticking doors, can indicate settlement — get a builder or structural engineer to look before patching.

Usually not. Most drywall contractors leave the wall sanded and primed (or just sanded), ready for your painter. Ask explicitly — some will prime and paint the patch for an extra fee, but colour-matching an aged painted wall often means repainting the whole wall.

Even a small patch takes 2-3 visits or one long day, because joint compound needs drying time between coats. A typical patch is fill day one, sand and second coat day two, final sand and ready for paint day three. Quick-set compounds can compress this to one day for small jobs.

Holes smaller than a fist are a reasonable DIY job with a patch kit. Anything larger than about 30 cm, ceiling repairs, or water damage is worth hiring out — matching the surrounding texture and getting invisible joints takes practice and proper tools.

GIB is NZ's dominant plasterboard brand, and 'stopping' is the Kiwi term for taping and finishing joints with compound. A 'GIB stopper' is the finishing trade you want for invisible repairs.