Aircon Servicing & Repair in Northland

A common rule: if the repair costs more than half the price of a new unit, or the system is over 10-12 years old and needs a compressor or coil replacement, replace it. Newer inverter units are typically 30-50% more efficient, so heavy users recoup part of the cost through lower bills.

A standard clean-and-check takes 30-45 minutes per indoor unit. A chemical wash takes about an hour per unit, and a full chemical overhaul (where the unit is dismantled) takes 1.5-2 hours per unit. Multi-unit visits are faster per unit.

Check the simple things first: thermostat mode and setpoint, dirty filters, and blocked outdoor unit airflow. If those are fine, the usual culprits are low refrigerant from a leak, a failed capacitor or fan motor, or a dirty coil. Low refrigerant always means a leak — a technician should find and fix the leak, not just top up the gas.

The most common cause is a clogged condensate drain line — dirt and algae block the pipe and water backs up into the room. Other causes are a dirty evaporator coil that ices over and then melts, a cracked drain pan, or an incorrectly sloped drain pipe. A drain flush during a standard service usually fixes it.

A chemical wash uses a cleaning solution to strip dirt and mould from the evaporator coil, blower wheel, and drain pan without dismantling the whole unit. Book one when a normal service no longer fixes weak airflow, bad smells, or water leaking from the indoor unit — typically every 12-18 months for heavily used units.

A standard service covers cleaning or replacing filters, cleaning the evaporator coil and blower, flushing the drainage tray and pipe, checking refrigerant pressure, testing thermostat and controls, and inspecting electrical connections. It does not include repairs, parts, or refrigerant top-ups — those are quoted separately.

A standard single-unit service is typically $120-$250, with multi-unit discounts. Deep hygiene cleans of mouldy indoor units run $200-$350. Winter is peak season in NZ since heat pumps are primarily used for heating — book a service in autumn.

Under the Healthy Homes Standards, rentals must have fixed heating capable of heating the main living room, which is often a heat pump — and the landlord is responsible for keeping it in working order. Tenants should clean filters and report faults in writing.