TV Mounting in Kelowna

Under 43 inches is a reasonable DIY job if you can find studs and use a level. From 55 inches up, a second pair of hands is essential and mistakes get expensive — a 65-inch panel weighs 20-25 kg and modern bezel-less screens crack easily if gripped wrong. Professionals also carry stud finders, cable detectors, and masonry drills most households lack.

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

Most TV mounting jobs are priced as a flat rate per TV, driven by three things: TV size, mount type (fixed, tilting, or full-motion), and wall material. Drywall or plasterboard with timber studs is the cheapest; brick, concrete, or above-fireplace installs cost more. Cable concealment is usually a separate add-on. Ask for the all-in price for your exact TV size and wall type before booking.

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

Small TVs (under about 40 inches) can go on hollow drywall with heavy-duty toggle anchors rated for the load, but most professionals prefer to hit at least one stud or install a plywood backing board. For TVs over 50 inches, mounting into studs or masonry is strongly recommended — anchor-only installs on hollow walls are the most common cause of fallen TVs.

Yes — high-rise condo party walls and exterior walls are often poured concrete, mounted with wedge or sleeve anchors using a hammer drill. Expect a premium over drywall rates, surface raceway instead of in-wall concealment, and check your condo bylaws: some boards restrict drilling hours or require notice.

A licensed electrician only. In Ontario, the work must be done or declared through an ESA-licensed contractor; other provinces have equivalent bodies (e.g., Technical Safety BC). Many TV installers partner with an electrician — bundling it into one visit typically costs less than two call-outs.