TV Mounting in Abbotsford

Yes — brick and concrete are actually stronger than drywall for mounting. The installer uses a hammer drill and masonry anchors (sleeve or wedge anchors). It costs more than a stud wall because drilling is slower and cable concealment usually has to run in surface trunking rather than inside the wall.

A standard install on a stud or masonry wall takes 30-90 minutes. Add 1-2 hours if cables are being concealed inside the wall, and more again for above-fireplace installs or walls that need reinforcement. Book a 2-hour window to be safe.

Under 43 inches is a reasonable DIY job if you can find studs and use a level. From 55 inches up, a second pair of hands is essential and mistakes get expensive — a 65-inch panel weighs 20-25 kg and modern bezel-less screens crack easily if gripped wrong. Professionals also carry stud finders, cable detectors, and masonry drills most households lack.

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

Fixed mounts sit flattest against the wall and are cheapest. Tilting mounts angle down 5-15 degrees — useful when the TV sits above eye level. Full-motion (articulating) mounts extend and swivel, which suits corner installs or rooms with multiple viewing positions; they cost the most and need the most secure fixing because the load hangs away from the wall.

Either works. Buying your own mount is usually cheaper — check it matches your TV's VESA pattern (the four bolt holes on the back, e.g. 400x400) and its rated weight. Many installers also sell mounts on the day at a markup of roughly 20-50% over retail. If you buy your own, tell the installer the model so they bring the right fixings.

Yes — high-rise condo party walls and exterior walls are often poured concrete, mounted with wedge or sleeve anchors using a hammer drill. Expect a premium over drywall rates, surface raceway instead of in-wall concealment, and check your condo bylaws: some boards restrict drilling hours or require notice.

A licensed electrician only. In Ontario, the work must be done or declared through an ESA-licensed contractor; other provinces have equivalent bodies (e.g., Technical Safety BC). Many TV installers partner with an electrician — bundling it into one visit typically costs less than two call-outs.