Lighting Installation in Quebec

Per fixture for straightforward swaps (replacing a pendant or fitting downlights into existing wiring), hourly for exploratory or fault work, and quoted per project for new circuits, dimmers across rooms, or outdoor schemes. Height, ceiling access and whether wiring exists at the point drive cost more than the fixture itself.

Common culprits: non-dimmable LEDs on a dimmer, leading-edge dimmers driving LED loads, switch-loop induced ghost voltage, or cheap drivers. An electrician can match the dimmer to the load or fit a bypass capacitor — usually a quick, inexpensive fix.

Usually — it needs weatherproof (IP-rated) fittings, protected cable runs (buried or clipped), and often RCD/GFCI protection on the circuit. Low-voltage garden systems are cheaper to extend safely; mains-voltage outdoor work is firmly electrician territory.

Bathrooms have zoned rules: fittings near showers and baths must carry appropriate ingress protection (IP) ratings, and many jurisdictions restrict who may do the work. Choose IP44 or better near water and confirm the installer knows the zone requirements.

Swapping the switch is quick, but the dimmer must match the load type — LED lamps need trailing-edge dimmers and 'dimmable' rated bulbs, or you get flicker and buzz. Smart dimmers may also need a neutral at the switch, which older homes often lack.

Depends on the province and the work. In Ontario, electrical work for hire must be done by a Licensed Electrical Contractor — even fixture swaps. Other provinces are looser on like-for-like swaps. New wiring needs a licensed electrician and permit everywhere.