Lighting Installation in Mercier–Hochelaga-Maisonneuve

Bathrooms have zoned rules: fittings near showers and baths must carry appropriate ingress protection (IP) ratings, and many jurisdictions restrict who may do the work. Choose IP44 or better near water and confirm the installer knows the zone requirements.

Priced per point: cutting in, wiring and fitting each recessed light, with the first costing more than each additional one on the same run. Fire-rated housings, insulation-contact (IC) ratings, and dimming add per-unit cost. A typical room takes 4-8 downlights.

Usually — it needs weatherproof (IP-rated) fittings, protected cable runs (buried or clipped), and often RCD/GFCI protection on the circuit. Low-voltage garden systems are cheaper to extend safely; mains-voltage outdoor work is firmly electrician territory.

No — standard ceiling boxes/hooks hold only a few kilograms. Heavier fittings need a rated support fixed to structure, and stairwell or double-height installs need scaffolding or specialist access. Tell the installer the fixture weight and location when getting quotes.

Common culprits: non-dimmable LEDs on a dimmer, leading-edge dimmers driving LED loads, switch-loop induced ghost voltage, or cheap drivers. An electrician can match the dimmer to the load or fit a bypass capacitor — usually a quick, inexpensive fix.

Depends on the province and the work. In Ontario, electrical work for hire must be done by a Licensed Electrical Contractor — even fixture swaps. Other provinces are looser on like-for-like swaps. New wiring needs a licensed electrician and permit everywhere.