Irrigation & Sprinkler Systems in Melbourne City Centre

No backflow device where it's required, no zone-by-zone quote, no as-built diagram at handover, ignoring local water-restriction rules, and a design that waters everything on one zone regardless of plant needs. An installer who skips the backflow/compliance question is cutting a corner that can be illegal and unsafe.

Sprinklers (pop-up rotors/sprays) suit lawns; drip lines suit garden beds, hedges and pots because they deliver water slowly at the roots with far less evaporation and waste. Most good systems mix both — sprinkler zones for turf and drip zones for planting. Drip is the water-efficient choice where it fits.

In any climate that freezes, yes — water left in the pipes expands when it freezes and cracks lines, heads and valves, turning a cheap seasonal blow-out into an expensive spring repair. Warm, frost-free climates skip this but still benefit from an annual service. Ask whether winterization is included or a separate visit.

In-ground systems are priced per zone (a valve-controlled area) plus the controller, backflow device and any pump. Total cost scales with yard size, number of zones, and whether you use sprinkler heads, drip lines, or both. A small garden with a few zones is a fraction of a large multi-zone lawn-and-bed system.

Almost always where the system connects to mains/drinking water — a backflow preventer stops irrigation water (and any fertiliser or contaminants) siphoning back into the supply. Many areas legally require one, and some require it to be tested by a certified tester periodically. Confirm the local rule; it's a safety and compliance item, not an optional extra.

Automatic systems commonly run AUD 700-1,300 per zone installed, with a typical suburban yard at AUD 3,000-6,000. Water restrictions push dripline for beds and rain sensors; confirm whether GST is included.