Aircon Installation in Geraldton

A back-to-back single split is often a half-day job; a multi-split takes one to two days; ducted installs run two to four days depending on the ductwork. Long pipe runs, wall chasing and crane access for outdoor units add time.

Sizing is by room area, ceiling height, insulation, window area and sun exposure — a good installer does a load calculation, not a guess. An undersized unit runs constantly and never cools; an oversized one short-cycles and wastes energy. Insist on a sizing rationale in the quote.

A single-zone split unit for one room is the cheapest entry point; a multi-zone system serving several rooms is a mid-range job; a ducted/central system for a whole home is the priciest. The unit's size (in BTU/kW) and the difficulty of the pipe and cable runs drive cost more than the brand.

Clean or replace filters regularly, and have the system serviced roughly annually — coil clean, gas-pressure check and drainage clear. Skipping maintenance cuts efficiency, breeds mould in the drain, and shortens compressor life. Ask about a service plan at install.

Handling refrigerant is regulated almost everywhere — installers need the relevant certification (see country notes) and often a separate electrical licence for the power supply. Uncertified refrigerant work is both illegal and a common cause of leaks and voided warranties.

A single split runs about $1,500-5,000 installed; multi-head systems $5,000-14,000; ducted whole-home from around $9,000. Long pipe runs, second-storey installs and three-phase power push prices up.