Tiling in Bridgeport

Ask tilers in Bridgeport for photos of finished wet rooms and floor-to-wall junctions — lippage (uneven tile edges), crooked grout lines and bad cuts around fittings are where cheap work shows. Good tilers also talk about substrate prep and waterproofing before they talk about tiles.

Confirm five things: substrate prep (levelling, boards), waterproofing in wet areas, adhesive and grout type, cuts and trims (edge profiles), and silicone to finish. Tiles themselves are usually excluded, and removing old tiles is a separate line that can rival the laying cost.

A full bathroom (floor plus walls) typically takes 3-5 days: prep and waterproofing first, then setting, then grouting after the adhesive cures. Add days if old tiles must come off or the substrate needs levelling. Rushing cure times is the classic cause of cracked grout later.

Sometimes — if the old tiles are solidly bonded and the extra height works at doors and fittings, tiling over is legitimate and avoids messy removal. It fails when old tiles are drummy (hollow-sounding) or the wall can't take the weight. A good tiler taps and checks before promising either way.

Almost always substrate or installation, not the tile: movement in the floor, missing expansion joints, adhesive coverage too thin (spot-dabbing), or tiling over a drummy layer. Cracked single tiles from impact are replaceable if you kept spares — always keep a box.

Yes — tiles and grout are not waterproof; the membrane behind them is. Most countries mandate or strongly standardize wet-area waterproofing, and it must cure before tiling. If a bathroom quote doesn't mention waterproofing, that is the question to ask before anything else.

Labour typically runs $5-15 per sq ft for standard ceramic/porcelain floors, $10-25 for showers, mosaics and stone. A full tub-surround retile commonly lands $2,000-5,000 including demo and waterproofing, before tile cost.