Tile & Grout Cleaning in Yonkers

Yes for cement-based grout — a penetrating sealer slows re-staining and makes mopping more effective. Sealing is pointless on epoxy grout (already non-porous). Expect sealer to add meaningfully to the bill and need reapplying every 1-3 years in wet areas.

An alkaline pre-treatment to break down grease and soap scum, machine agitation with rotary brushes, then high-pressure hot water extraction that vacuums the dirty water away. It reaches into grout pores that mopping never touches.

Almost always by floor area (per square metre or square foot), with a minimum job charge. Sealing after cleaning, shower recesses, and heavily stained or epoxy-smeared grout cost extra. Wall tiles are quoted separately from floors.

Mopping pushes dirty water into porous grout lines, which sit lower than the tile face and act as gutters. After a professional clean, sealing the grout and switching to a flat microfibre mop with frequent rinse water dramatically slows re-soiling.

In Yonkers, pricing runs per square metre with a minimum callout, so small bathrooms cost proportionally more than large open-plan floors. Sealing roughly doubles the per-metre rate. Get the area measured and quoted in writing.

Marble, travertine and limestone need pH-neutral chemistry — acid-based tile cleaners etch them permanently. Tell the company your surface type up front; stone-safe cleaning and polishing is a different (pricier) service from ceramic/porcelain work.

A typical kitchen or bathroom floor takes 1-2 hours; a whole-house tiled floor half a day. Floors are walkable almost immediately after extraction, but wait 24 hours before wet-mopping, and longer if sealer was applied.

Most markets land between $0.75 and $3.00 per square foot depending on soil level and access, with minimum charges around $150-200. Add roughly $1 per square foot for penetrating grout sealer.