Kitchen Renovation in Florida

Open every door and drawer and check alignment and soft-close action; run the tap and check under-sink connections for weeps; test every appliance and outlet; check the benchtop for chips and sealant lines; confirm the splashback is sealed; and collect appliance warranties plus gas and electrical compliance certificates before releasing the final payment.

Ordering cabinets before finalizing appliance models; demolishing before cabinet delivery is confirmed; skimping on drawers (they beat cupboards for base storage); too few power outlets; no dedicated circuits for ovens and induction hobs; and treating ventilation as an afterthought — a recirculating hood where ducting was feasible is a permanent regret.

If the cabinet carcasses are sound and you like the layout, replacing doors, drawer fronts, hardware, and the benchtop delivers most of the visual change for roughly a third to half the cost of a full renovation. It is not worth it when carcasses are water-damaged, the layout fails you daily, or services need rework anyway — then you'd pay twice.

Hold 10-15% beyond the quote. The classic surprises are behind the old kitchen: degraded wiring that fails modern load requirements, corroded pipework, out-of-level floors that complicate cabinet installation, and walls that need replastering once tiles come off. Older properties justify the top of the range.

Appliances are the easiest item to self-supply because they are standardized and heavily discounted in sales — just lock in exact models before cabinets are ordered, since cabinet openings are built to them. Let the contractor handle anything built-in that affects warranty or gas/electrical certification, and agree in writing who is responsible if a self-supplied appliance arrives late or damaged.

Minor remodels (same layout, refaced or stock cabinets) run roughly $10,000-$25,000; a full mid-range remodel typically lands $25,000-$60,000; major upscale projects run $60,000-$150,000. Industry cost-vs-value data consistently shows minor kitchen remodels recouping a higher share of cost at resale than upscale ones.

Cabinet and countertop replacement in place generally doesn't; moving the sink or gas range, adding circuits, or removing walls does — permits come from your city or county building department. Your contractor should pull them; a homeowner-pulled permit shifts inspection liability onto you.