Irrigation & Sprinkler Systems in Andover

A zone is a group of sprinklers or drippers controlled by one valve, watering an area with similar needs. You need separate zones because lawn, garden beds and shady areas want different amounts of water, and water pressure limits how many heads run at once. More zones means better watering but higher cost.

Use an installer in Andover who designs to your yard (zones matched to sun, soil and plant type), knows local backflow and water-use rules, and gives an itemized quote by zone. Ask for references and a system as-built diagram at handover so future repairs are easy. Water-efficiency knowledge matters most in dry regions.

Almost always where the system connects to mains/drinking water — a backflow preventer stops irrigation water (and any fertiliser or contaminants) siphoning back into the supply. Many areas legally require one, and some require it to be tested by a certified tester periodically. Confirm the local rule; it's a safety and compliance item, not an optional extra.

In-ground systems are priced per zone (a valve-controlled area) plus the controller, backflow device and any pump. Total cost scales with yard size, number of zones, and whether you use sprinkler heads, drip lines, or both. A small garden with a few zones is a fraction of a large multi-zone lawn-and-bed system.

In any climate that freezes, yes — water left in the pipes expands when it freezes and cracks lines, heads and valves, turning a cheap seasonal blow-out into an expensive spring repair. Warm, frost-free climates skip this but still benefit from an annual service. Ask whether winterization is included or a separate visit.

In-ground systems commonly run $500-1,000 per zone, with a typical yard installed at $2,500-5,000 and larger properties more. Repairs (heads, valves, controller) usually run $75-300; seasonal winterization $75-150.