Garage Door Repair in Connecticut

A service covers spring tension and balance, cable and roller condition, track alignment, hardware tightening, lubrication and opener safety tests (auto-reverse). Annually serviced doors break far less and their openers last longer — it's the cheapest insurance this trade sells.

Most repairs are call-out jobs: spring, cable and roller replacements sit at the low-to-mid range, opener (motor) repairs or replacement mid-range, and panel or track damage from vehicle impact at the top. Full door replacement is quoted separately per door size and material.

The most common culprits, in order: a snapped torsion spring (you'll often hear the bang), a failed opener or its remote/keypad batteries, a disengaged emergency release, or a blocked/misaligned safety sensor making the opener refuse to run. Springs and openers are pro repairs; sensors you can often realign yourself.

Yes — genuinely. Torsion springs store enough energy to cause serious injury when unwound incorrectly, and they're the single most common cause of garage-door DIY accidents. Spring replacement is cheap professional work; there is no good reason to DIY it.

On a two-spring door, yes — springs wear together, and the surviving spring is usually near the end of its rated cycles. Replacing both in one visit costs little more than one and avoids a second call-out within months. High-cycle springs are worth the small premium for busy doors.

Openers typically last 10-15 years. Replacement makes sense when the logic board or motor fails outside warranty — modern units add safety reversal, quieter belt drives and smartphone control. Installation on an existing well-balanced door is a 2-3 hour job.

Torsion spring replacement typically runs $200-400 for both springs on a standard double door, parts and labour. Opener replacement lands $350-800 installed. If someone quotes $800+ for springs alone, get a second opinion.