Concrete Work in Massachusetts

Surface spalling, small cracks and pitting can be patched, resurfaced with an overlay, or ground back. Slabs that have sunk can sometimes be lifted with foam or grout injection ('slabjacking') for far less than replacement. Structural failure or widespread base movement means replacement.

Strongly. Frost can ruin an uncured pour, extreme heat causes plastic shrinkage cracking, and rain marks fresh surfaces. Good contractors watch forecasts and will delay a pour; be suspicious of anyone happy to pour into bad weather to keep the schedule.

You can usually walk on it after 24-48 hours, drive on it after about 7 days, and it reaches design strength at 28 days. Curing (keeping it damp, protecting from frost or extreme heat) in the first week matters more for durability than almost anything else.

Excavation and sub-base, formwork, reinforcement (mesh size or fibre dose), concrete grade and thickness, the finish (broom, trowel, exposed aggregate, stamped), control joints, curing method, and spoil removal. Any quote that just says 'supply and lay concrete' leaves too much undefined.

Concrete is priced by area and thickness for slabs (per m² or sq ft), by volume for supply (per cubic metre/yard), and by the job for repairs. The concrete itself is often less than half the bill — formwork, reinforcement, sub-base preparation, finishing and access drive the labour cost.

Plain gray flatwork typically runs $6-12 per sq ft installed; stamped, colored or exposed-aggregate finishes run $12-25+. Ready-mix supply alone is roughly $130-180 per cubic yard before labor.