Water Heater Installation & Repair in Strood

Yes: annual or biennial sediment flush, anode rod check every 2-3 years in hard-water areas, and TPR (pressure relief) valve testing. Tankless units need periodic descaling. Maintenance is the difference between an 8-year and a 15-year unit.

Rule of thumb for storage: 30-40L per person per day of heated storage for typical use — a family of four lands around 150-200L (40-50 gal). For tankless, size by simultaneous outlets and the temperature rise your groundwater requires; your installer should calculate, not guess.

Like-for-like tank swaps take 2-4 hours. Fuel-type changes, relocations, tankless conversions, or units needing new circuits/venting run half a day to a full day plus possible permit inspections.

Repair thermostats, elements, and valves on younger units. Replace when the tank shell leaks, the unit is past 8-10 years and needs a major part, or repair quotes exceed roughly a third of replacement cost. Efficiency gains from a modern unit often tip old-unit decisions to replace.

A leaking tank can fail suddenly and flood, and any leak near electrics is hazardous. Shut off the unit's power (or gas) and its cold-water feed valve, then call a professional. A dripping pressure-relief valve specifically signals over-pressure or over-temperature — don't cap it.

In Strood, a like-for-like storage tank swap is the baseline job; tankless conversions, relocations, and code upgrades (valves, drains, seismic strapping where required) add cost. Get itemised quotes separating unit price from labour and disposal.

G3 is the Building Regulations qualification for unvented (mains-pressure) hot water cylinders — pressurised vessels that can explode if safety controls are wrongly fitted. Installation by a non-G3 installer is a building-regs breach, can void insurance, and surfaces at conveyancing.