Water Heater Installation & Repair in Greenford

Storage tanks: 8-12 years (longer with soft water and anode-rod changes). Tankless/instantaneous units: 15-20 years with descaling. Heat pump water heaters: 10-15 years. A tank leaking from the shell itself is end-of-life — replace, don't repair.

Yes: annual or biennial sediment flush, anode rod check every 2-3 years in hard-water areas, and TPR (pressure relief) valve testing. Tankless units need periodic descaling. Maintenance is the difference between an 8-year and a 15-year unit.

Rule of thumb for storage: 30-40L per person per day of heated storage for typical use — a family of four lands around 150-200L (40-50 gal). For tankless, size by simultaneous outlets and the temperature rise your groundwater requires; your installer should calculate, not guess.

Like-for-like tank swaps take 2-4 hours. Fuel-type changes, relocations, tankless conversions, or units needing new circuits/venting run half a day to a full day plus possible permit inspections.

Repair thermostats, elements, and valves on younger units. Replace when the tank shell leaks, the unit is past 8-10 years and needs a major part, or repair quotes exceed roughly a third of replacement cost. Efficiency gains from a modern unit often tip old-unit decisions to replace.

G3 is the Building Regulations qualification for unvented (mains-pressure) hot water cylinders — pressurised vessels that can explode if safety controls are wrongly fitted. Installation by a non-G3 installer is a building-regs breach, can void insurance, and surfaces at conveyancing.