Water Heater Installation & Repair near you in United Kingdom

A leaking tank can fail suddenly and flood, and any leak near electrics is hazardous. Shut off the unit's power (or gas) and its cold-water feed valve, then call a professional. A dripping pressure-relief valve specifically signals over-pressure or over-temperature — don't cap it.

Yes: annual or biennial sediment flush, anode rod check every 2-3 years in hard-water areas, and TPR (pressure relief) valve testing. Tankless units need periodic descaling. Maintenance is the difference between an 8-year and a 15-year unit.

Rule of thumb for storage: 30-40L per person per day of heated storage for typical use — a family of four lands around 150-200L (40-50 gal). For tankless, size by simultaneous outlets and the temperature rise your groundwater requires; your installer should calculate, not guess.

Usually sediment buildup eating tank capacity, a failed lower heating element, or a broken dip tube mixing cold into the draw. All are diagnosable in one visit; sediment flushing and element swaps are routine repairs on a healthy tank.

Like-for-like tank swaps take 2-4 hours. Fuel-type changes, relocations, tankless conversions, or units needing new circuits/venting run half a day to a full day plus possible permit inspections.

Tankless gives endless hot water and saves space and standby losses, but costs more installed and may need electrical or gas-supply upgrades. Storage tanks are cheaper to buy and fix and handle simultaneous use predictably. Household size, fuel type, and usage pattern decide it.

Repair thermostats, elements, and valves on younger units. Replace when the tank shell leaks, the unit is past 8-10 years and needs a major part, or repair quotes exceed roughly a third of replacement cost. Efficiency gains from a modern unit often tip old-unit decisions to replace.

G3 is the Building Regulations qualification for unvented (mains-pressure) hot water cylinders — pressurised vessels that can explode if safety controls are wrongly fitted. Installation by a non-G3 installer is a building-regs breach, can void insurance, and surfaces at conveyancing.