TV Mounting in Mansfield

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

Most will, as a small add-on — typically a quarter to half the price of a fresh install. Dismount-and-remount in a new home (or after moving the sofa) is a standard job; mention it when booking so the installer brings patching filler for the old holes.

Search for handymen or dedicated TV installers in Mansfield with recent reviews that mention your wall type (drywall, brick, or concrete). Ask three things up front: the flat price for your TV size and wall type, whether they carry liability insurance, and whether cable concealment is included or an add-on. A good installer asks about your wall and TV model before quoting.

Either works. Buying your own mount is usually cheaper — check it matches your TV's VESA pattern (the four bolt holes on the back, e.g. 400x400) and its rated weight. Many installers also sell mounts on the day at a markup of roughly 20-50% over retail. If you buy your own, tell the installer the model so they bring the right fixings.

Fixed mounts sit flattest against the wall and are cheapest. Tilting mounts angle down 5-15 degrees — useful when the TV sits above eye level. Full-motion (articulating) mounts extend and swivel, which suits corner installs or rooms with multiple viewing positions; they cost the most and need the most secure fixing because the load hangs away from the wall.

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

Yes — dot-and-dab (plasterboard glued over brick or block, common in post-1980s UK homes) needs special fixings such as corefix bolts that pass through the board into the masonry behind. Standard plasterboard anchors alone are not safe for TVs over about 40 inches on these walls, so tell the installer if your wall sounds hollow but feels solid behind.

No. Hiding aerial and HDMI cables in the wall or in trunking is not notifiable work. Part P applies only if you add a new socket, fused spur, or extend a circuit behind the TV — that part must be done by a registered electrician (NICEIC/NAPIT) or notified to building control.