TV Mounting in Colchester

Not for the mounting itself. You need one only if you want a new power outlet behind the TV, since fixed wiring is electrician-only work in most countries. Many TV mounting companies partner with an electrician or offer the outlet as an add-on — ask when booking so it happens in one visit.

Either works. Buying your own mount is usually cheaper — check it matches your TV's VESA pattern (the four bolt holes on the back, e.g. 400x400) and its rated weight. Many installers also sell mounts on the day at a markup of roughly 20-50% over retail. If you buy your own, tell the installer the model so they bring the right fixings.

Yes, and it is cheaper to bundle than to book twice. Soundbar brackets attach either to the wall below the TV or to the TV mount itself. Consoles and set-top boxes go on a small floating shelf or behind-TV bracket. Expect a modest add-on charge per extra device, plus cable management for each.

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

Yes — dot-and-dab (plasterboard glued over brick or block, common in post-1980s UK homes) needs special fixings such as corefix bolts that pass through the board into the masonry behind. Standard plasterboard anchors alone are not safe for TVs over about 40 inches on these walls, so tell the installer if your wall sounds hollow but feels solid behind.

No. Hiding aerial and HDMI cables in the wall or in trunking is not notifiable work. Part P applies only if you add a new socket, fused spur, or extend a circuit behind the TV — that part must be done by a registered electrician (NICEIC/NAPIT) or notified to building control.