Concrete Work in Merthyr Tydfil

Excavation and sub-base, formwork, reinforcement (mesh size or fibre dose), concrete grade and thickness, the finish (broom, trowel, exposed aggregate, stamped), control joints, curing method, and spoil removal. Any quote that just says 'supply and lay concrete' leaves too much undefined.

Broom (non-slip, standard outdoors), steel trowel (smooth, indoor), exposed aggregate, stamped/patterned, coloured and polished. Decorative finishes can add 30-100% to the base rate but replace the cost of a separate surface like pavers or tiles.

Look for crews who do concrete daily, not general handymen — finishing is a perishable skill and a two-hour window decides how the slab looks forever. In Merthyr Tydfil, ask for addresses of slabs poured a few years ago and look at the joints and edges, which is where poor work shows first.

Strongly. Frost can ruin an uncured pour, extreme heat causes plastic shrinkage cracking, and rain marks fresh surfaces. Good contractors watch forecasts and will delay a pour; be suspicious of anyone happy to pour into bad weather to keep the schedule.

Concrete is priced by area and thickness for slabs (per m² or sq ft), by volume for supply (per cubic metre/yard), and by the job for repairs. The concrete itself is often less than half the bill — formwork, reinforcement, sub-base preparation, finishing and access drive the labour cost.

Common rules of thumb: 75-100mm (3-4") for paths and patios, 100-125mm (4-5") for driveways and garage floors, more for heavy vehicles — always over a compacted sub-base with mesh or fibre reinforcement. Thin slabs on soft ground crack no matter how good the finish looks.

You can usually walk on it after 24-48 hours, drive on it after about 7 days, and it reaches design strength at 28 days. Curing (keeping it damp, protecting from frost or extreme heat) in the first week matters more for durability than almost anything else.

Supply-only ready-mix typically runs £100-150 per m³ plus delivery, with small-load surcharges under about 4m³. Laid-and-finished flatwork comes to roughly £70-120 per m² including base preparation.