Carpentry in Gateshead

Photos of finished work at close range (joints, edges, scribing against uneven walls tell you everything), proof of insurance, and references from jobs similar to yours. In Gateshead, check whether your job size triggers any local licensing requirement before work starts.

Setup dominates: travel, tool setup, dust protection and cleanup take the same time whether the cutting takes one hour or eight. Many carpenters in Gateshead charge a half-day minimum, so batching several small jobs into one visit is the cheapest way to buy their time.

Depends where you live: some jurisdictions license structural or high-value carpentry work, while trim and furniture work is unlicensed almost everywhere. For structural jobs (framing, load-bearing changes), check Gateshead's local rules — and always verify insurance regardless of licensing.

Door hanging and adjustment, skirting/trim and architraves, custom shelving and built-in wardrobes, stair repairs, timber framing, decking frames, stud walls, and repair of rot or damaged timber. Anything cut and fitted from wood on site is carpentry territory.

Carpenters charge by the hour, by the day, or per project for defined jobs like built-ins. Rates vary with specialisation: rough/framing carpentry is priced into construction budgets, while finish carpentry (trim, doors, built-ins) commands higher hourly rates for slower, more precise work.

Yes — splice repairs, resin treatments and section replacement are standard work. But rot is a symptom: the leak or damp source must be fixed first or the repair fails. A good carpenter will point at the water source before quoting the timber fix.

Photos plus measurements get you a ballpark; a site visit gets you a real number. Specify materials, finish (painted, stained, veneer) and hardware up front — 'a shelf' can cost 5x more in walnut with soft-close fittings than in painted MDF.

Roughly £180-280 per day outside London, more inside it. Fitted wardrobes and alcove units are usually priced per project — a typical painted MDF alcove unit runs £600-1,500 fitted.