Water Heater Installation & Repair in National Capital Region

Like-for-like tank swaps take 2-4 hours. Fuel-type changes, relocations, tankless conversions, or units needing new circuits/venting run half a day to a full day plus possible permit inspections.

Yes: annual or biennial sediment flush, anode rod check every 2-3 years in hard-water areas, and TPR (pressure relief) valve testing. Tankless units need periodic descaling. Maintenance is the difference between an 8-year and a 15-year unit.

Repair thermostats, elements, and valves on younger units. Replace when the tank shell leaks, the unit is past 8-10 years and needs a major part, or repair quotes exceed roughly a third of replacement cost. Efficiency gains from a modern unit often tip old-unit decisions to replace.

Usually sediment buildup eating tank capacity, a failed lower heating element, or a broken dip tube mixing cold into the draw. All are diagnosable in one visit; sediment flushing and element swaps are routine repairs on a healthy tank.

A leaking tank can fail suddenly and flood, and any leak near electrics is hazardous. Shut off the unit's power (or gas) and its cold-water feed valve, then call a professional. A dripping pressure-relief valve specifically signals over-pressure or over-temperature — don't cap it.

Only if a dedicated, properly grounded circuit with RCD/ELCB protection can be run — a 4.5kW heater draws ~20A, far beyond a shared outlet circuit. The heater itself is cheap; the safe wiring is the real job. Never accept an install off an existing circuit.