Drywall Installation & Repair in Buenavista

Drywall (plasterboard) repair replaces or patches board sheets and finishes the joints with tape and compound. Traditional plastering applies wet plaster coats over masonry or lath. Older homes often have solid plaster walls that need a plasterer, not a drywall contractor.

Holes smaller than a fist are a reasonable DIY job with a patch kit. Anything larger than about 30 cm, ceiling repairs, or water damage is worth hiring out — matching the surrounding texture and getting invisible joints takes practice and proper tools.

If board has swollen, sagged, or grown mould it must be cut out and replaced — drying alone is not enough. Fix the leak first, cut back at least 30 cm beyond visible damage, and let the cavity dry before new board goes in. Persistent damp needs a moisture-meter check.

Even a small patch takes 2-3 visits or one long day, because joint compound needs drying time between coats. A typical patch is fill day one, sand and second coat day two, final sand and ready for paint day three. Quick-set compounds can compress this to one day for small jobs.

Yes, almost all do. Small patches are priced as a minimum call-out (often 1-2 hours of labour plus materials) because of travel and return visits for coats. Bundling several small repairs into one visit is the cheapest way to get patches done.

Interior partitions and ceilings in condos and newer homes are commonly gypsum board on metal studs; exterior and older walls are concrete hollow block. Ceiling repairs after roof leaks are the most common drywall job — fix the roof first or the board will fail again in the next rainy season.