Aircon Servicing & Repair in Sandakan

A standard service covers cleaning or replacing filters, cleaning the evaporator coil and blower, flushing the drainage tray and pipe, checking refrigerant pressure, testing thermostat and controls, and inspecting electrical connections. It does not include repairs, parts, or refrigerant top-ups — those are quoted separately.

A chemical wash uses a cleaning solution to strip dirt and mould from the evaporator coil, blower wheel, and drain pan without dismantling the whole unit. Book one when a normal service no longer fixes weak airflow, bad smells, or water leaking from the indoor unit — typically every 12-18 months for heavily used units.

The most common cause is a clogged condensate drain line — dirt and algae block the pipe and water backs up into the room. Other causes are a dirty evaporator coil that ices over and then melts, a cracked drain pan, or an incorrectly sloped drain pipe. A drain flush during a standard service usually fixes it.

Check the simple things first: thermostat mode and setpoint, dirty filters, and blocked outdoor unit airflow. If those are fine, the usual culprits are low refrigerant from a leak, a failed capacitor or fan motor, or a dirty coil. Low refrigerant always means a leak — a technician should find and fix the leak, not just top up the gas.

A standard clean-and-check takes 30-45 minutes per indoor unit. A chemical wash takes about an hour per unit, and a full chemical overhaul (where the unit is dismantled) takes 1.5-2 hours per unit. Multi-unit visits are faster per unit.

Normal service is RM50-RM90 per unit (bundles cheaper per unit), chemical wash RM130-RM200 per unit, and chemical overhaul RM250-RM400 per unit. Gas top-up, when genuinely needed, adds RM50-RM150 for R32/R410A depending on amount.

Every 3 months for daily-use bedrooms and living rooms; haze season (usually mid-year) clogs filters faster, so check filters monthly during haze episodes. A chemical wash every 12-18 months keeps cooling strong in Malaysian humidity.