Lighting Installation in Bray

Bathrooms have zoned rules: fittings near showers and baths must carry appropriate ingress protection (IP) ratings, and many jurisdictions restrict who may do the work. Choose IP44 or better near water and confirm the installer knows the zone requirements.

Usually — it needs weatherproof (IP-rated) fittings, protected cable runs (buried or clipped), and often RCD/GFCI protection on the circuit. Low-voltage garden systems are cheaper to extend safely; mains-voltage outdoor work is firmly electrician territory.

Common culprits: non-dimmable LEDs on a dimmer, leading-edge dimmers driving LED loads, switch-loop induced ghost voltage, or cheap drivers. An electrician can match the dimmer to the load or fit a bypass capacitor — usually a quick, inexpensive fix.

Per fixture for straightforward swaps (replacing a pendant or fitting downlights into existing wiring), hourly for exploratory or fault work, and quoted per project for new circuits, dimmers across rooms, or outdoor schemes. Height, ceiling access and whether wiring exists at the point drive cost more than the fixture itself.

Rules vary by country — some allow DIY like-for-like swaps, others make almost all fixed wiring licensed work. Beyond legality: anything involving new cabling, no earth wire present, unfamiliar switch loops, or bathroom zones is genuinely worth a professional regardless.

For restricted works — new circuits, fuse board work — yes, by law. Simple like-for-like fitting swaps aren't restricted, but older Irish homes frequently lack circuit earths, which makes a registered contractor the sensible choice anyway.