TV Mounting in Stróvolos

Either works. Buying your own mount is usually cheaper — check it matches your TV's VESA pattern (the four bolt holes on the back, e.g. 400x400) and its rated weight. Many installers also sell mounts on the day at a markup of roughly 20-50% over retail. If you buy your own, tell the installer the model so they bring the right fixings.

Small TVs (under about 40 inches) can go on hollow drywall with heavy-duty toggle anchors rated for the load, but most professionals prefer to hit at least one stud or install a plywood backing board. For TVs over 50 inches, mounting into studs or masonry is strongly recommended — anchor-only installs on hollow walls are the most common cause of fallen TVs.

Yes if done properly, but check two things: heat (run the fireplace for 30 minutes and confirm the wall above stays below about 40C / 100F, or fit a mantel to deflect heat) and viewing angle (a pull-down or tilting mount stops neck strain). Above-fireplace installs cost more because the wall is usually brick or stone and cable routing is harder.

Yes — brick and concrete are actually stronger than drywall for mounting. The installer uses a hammer drill and masonry anchors (sleeve or wedge anchors). It costs more than a stud wall because drilling is slower and cable concealment usually has to run in surface trunking rather than inside the wall.

Fixed mounts sit flattest against the wall and are cheapest. Tilting mounts angle down 5-15 degrees — useful when the TV sits above eye level. Full-motion (articulating) mounts extend and swivel, which suits corner installs or rooms with multiple viewing positions; they cost the most and need the most secure fixing because the load hangs away from the wall.

Local wage levels — expect roughly half to two-thirds of UK rates for the same job. English-speaking expat-focused handymen in Paphos and Limassol sometimes charge a premium over Greek-Cypriot local rates, so compare at least two quotes.

Rarely — walls are solid brick or concrete with no cavity. Installers run cables in slim paintable trunking, or chase a channel into the wall during renovation-level works. If a socket move is involved, use an EMS-licensed electrician.