TV Mounting in Windsor

A standard install on a stud or masonry wall takes 30-90 minutes. Add 1-2 hours if cables are being concealed inside the wall, and more again for above-fireplace installs or walls that need reinforcement. Book a 2-hour window to be safe.

Yes if done properly, but check two things: heat (run the fireplace for 30 minutes and confirm the wall above stays below about 40C / 100F, or fit a mantel to deflect heat) and viewing angle (a pull-down or tilting mount stops neck strain). Above-fireplace installs cost more because the wall is usually brick or stone and cable routing is harder.

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

Yes — high-rise condo party walls and exterior walls are often poured concrete, mounted with wedge or sleeve anchors using a hammer drill. Expect a premium over drywall rates, surface raceway instead of in-wall concealment, and check your condo bylaws: some boards restrict drilling hours or require notice.

A licensed electrician only. In Ontario, the work must be done or declared through an ESA-licensed contractor; other provinces have equivalent bodies (e.g., Technical Safety BC). Many TV installers partner with an electrician — bundling it into one visit typically costs less than two call-outs.