Tile & Grout Cleaning in Edmonton

Mopping pushes dirty water into porous grout lines, which sit lower than the tile face and act as gutters. After a professional clean, sealing the grout and switching to a flat microfibre mop with frequent rinse water dramatically slows re-soiling.

In Edmonton, pricing runs per square metre with a minimum callout, so small bathrooms cost proportionally more than large open-plan floors. Sealing roughly doubles the per-metre rate. Get the area measured and quoted in writing.

Marble, travertine and limestone need pH-neutral chemistry — acid-based tile cleaners etch them permanently. Tell the company your surface type up front; stone-safe cleaning and polishing is a different (pricier) service from ceramic/porcelain work.

A typical kitchen or bathroom floor takes 1-2 hours; a whole-house tiled floor half a day. Floors are walkable almost immediately after extraction, but wait 24 hours before wet-mopping, and longer if sealer was applied.

Surface dirt, grease and most mould clean off well. Grout that is stained through its depth, or was never sealed and has absorbed years of dirty mop water, may only lighten. The fallback options are grout colour-sealing or re-grouting.

Salt residue tracked in over winter leaves white haze and slowly degrades cement grout. An annual spring clean with alkaline pre-treatment strips the residue; sealing entry-area grout before winter makes the next spring far easier.