Concrete Work in Dovercourt-Wallace Emerson-Junction

Hairline shrinkage cracks are normal; that is what control joints are for — they give cracking a straight place to happen. Wide, uneven or lifting cracks signal a base, reinforcement or curing problem. If a new slab cracks outside its joints within months, call the contractor back.

Look for crews who do concrete daily, not general handymen — finishing is a perishable skill and a two-hour window decides how the slab looks forever. In Dovercourt-Wallace Emerson-Junction, ask for addresses of slabs poured a few years ago and look at the joints and edges, which is where poor work shows first.

You can usually walk on it after 24-48 hours, drive on it after about 7 days, and it reaches design strength at 28 days. Curing (keeping it damp, protecting from frost or extreme heat) in the first week matters more for durability than almost anything else.

Broom (non-slip, standard outdoors), steel trowel (smooth, indoor), exposed aggregate, stamped/patterned, coloured and polished. Decorative finishes can add 30-100% to the base rate but replace the cost of a separate surface like pavers or tiles.

Common rules of thumb: 75-100mm (3-4") for paths and patios, 100-125mm (4-5") for driveways and garage floors, more for heavy vehicles — always over a compacted sub-base with mesh or fibre reinforcement. Thin slabs on soft ground crack no matter how good the finish looks.

Usually the wrong mix (no air entrainment), finishing water into the surface, or salting a first-year slab. Insist on the CSA exposure-class mix, proper curing, and avoid de-icing salt during the first winter.