Aircon Servicing & Repair in Quebec

A unit that trips the breaker at startup usually has a failing compressor, a shorted capacitor, or a wiring fault — all electrical faults that need a technician. Do not keep resetting the breaker; repeated tripping can damage the compressor beyond repair.

Dirty coils and filters make the compressor work harder for the same cooling — energy use can rise 15-30% before you notice weaker airflow. A failing capacitor or low refrigerant has the same effect. A service that restores the unit to spec usually pays for itself in a hot season.

If you run multiple units daily, yes — contracts usually price each visit 15-30% below one-off rates, include priority booking during heatwaves, and some include minor parts. For a single, lightly used unit, paying per visit is usually cheaper.

A standard clean-and-check takes 30-45 minutes per indoor unit. A chemical wash takes about an hour per unit, and a full chemical overhaul (where the unit is dismantled) takes 1.5-2 hours per unit. Multi-unit visits are faster per unit.

A chemical wash uses a cleaning solution to strip dirt and mould from the evaporator coil, blower wheel, and drain pan without dismantling the whole unit. Book one when a normal service no longer fixes weak airflow, bad smells, or water leaking from the indoor unit — typically every 12-18 months for heavily used units.

Yes — federal and provincial programs (e.g. Canada Greener Homes-successor programs, provincial utility rebates) offer meaningful rebates for replacing AC/furnace setups with cold-climate heat pumps. Amounts change by province and year, so ask the contractor which programs your equipment qualifies for and get it in writing.

May-June, before the short cooling season peaks. Many homeowners bundle a spring AC tune-up with a fall furnace service; combined maintenance plans typically cost less than two separate visits.