Aircon Servicing & Repair in Maple Ridge

Inverter units vary compressor speed instead of switching on and off, so they hold temperature more steadily and cost 20-40% less to run for long daily use. Non-inverter units are cheaper upfront and fine for rooms cooled a few hours a day. For daily whole-day use, the inverter premium usually pays back in 2-3 years.

You can safely wash or replace filters monthly, keep the outdoor unit clear of leaves and debris, and wipe the indoor casing. Anything involving the refrigerant circuit, electrical components, or coil chemicals should be left to a certified technician — refrigerant handling is legally restricted in most countries.

The most common cause is a clogged condensate drain line — dirt and algae block the pipe and water backs up into the room. Other causes are a dirty evaporator coil that ices over and then melts, a cracked drain pan, or an incorrectly sloped drain pipe. A drain flush during a standard service usually fixes it.

A chemical wash cleans the coil, blower, and drain pan in place. A chemical overhaul dismantles the indoor unit completely, soaks the parts, checks bearings and seals, and reassembles it. Choose an overhaul when a wash has not fixed persistent leaks, noise, or weak cooling, or for units neglected for years.

A common rule: if the repair costs more than half the price of a new unit, or the system is over 10-12 years old and needs a compressor or coil replacement, replace it. Newer inverter units are typically 30-50% more efficient, so heavy users recoup part of the cost through lower bills.

Once a year is the minimum for a system used seasonally; every 3-4 months if you run it daily in a hot climate. Regular servicing keeps coils and filters clean, which protects the compressor — the most expensive part to replace — and keeps energy use down.

Yes — federal and provincial programs (e.g. Canada Greener Homes-successor programs, provincial utility rebates) offer meaningful rebates for replacing AC/furnace setups with cold-climate heat pumps. Amounts change by province and year, so ask the contractor which programs your equipment qualifies for and get it in writing.

May-June, before the short cooling season peaks. Many homeowners bundle a spring AC tune-up with a fall furnace service; combined maintenance plans typically cost less than two separate visits.