Aircon Installation in West Vancouver

Sizing is by room area, ceiling height, insulation, window area and sun exposure — a good installer does a load calculation, not a guess. An undersized unit runs constantly and never cools; an oversized one short-cycles and wastes energy. Insist on a sizing rationale in the quote.

A single-zone split unit for one room is the cheapest entry point; a multi-zone system serving several rooms is a mid-range job; a ducted/central system for a whole home is the priciest. The unit's size (in BTU/kW) and the difficulty of the pipe and cable runs drive cost more than the brand.

Clean or replace filters regularly, and have the system serviced roughly annually — coil clean, gas-pressure check and drainage clear. Skipping maintenance cuts efficiency, breeds mould in the drain, and shortens compressor life. Ask about a service plan at install.

Handling refrigerant is regulated almost everywhere — installers need the relevant certification (see country notes) and often a separate electrical licence for the power supply. Uncertified refrigerant work is both illegal and a common cause of leaks and voided warranties.

In West Vancouver, expect the national typical for a standard split-system install, with high-rise access, long refrigerant runs and electrical upgrades pushing you toward the top of the range. Get itemised quotes covering unit, install and any electrical work.

For most Canadian homes yes — a cold-climate heat pump both cools in summer and heats in shoulder seasons, and rebates offset the higher upfront cost. Cooling-only AC only makes sense where you already have efficient heating.