TV Mounting in Dubai

In hollow drywall or plasterboard walls, yes — installers cut two small openings and drop low-voltage cables (HDMI, antenna) inside the cavity. Power cables usually cannot legally go in-wall as ordinary extension leads; the compliant options are an in-wall rated power relocation kit or a new outlet behind the TV installed by an electrician. On solid brick or concrete walls, cables run in paintable surface trunking instead.

Small TVs (under about 40 inches) can go on hollow drywall with heavy-duty toggle anchors rated for the load, but most professionals prefer to hit at least one stud or install a plywood backing board. For TVs over 50 inches, mounting into studs or masonry is strongly recommended — anchor-only installs on hollow walls are the most common cause of fallen TVs.

Under 43 inches is a reasonable DIY job if you can find studs and use a level. From 55 inches up, a second pair of hands is essential and mistakes get expensive — a 65-inch panel weighs 20-25 kg and modern bezel-less screens crack easily if gripped wrong. Professionals also carry stud finders, cable detectors, and masonry drills most households lack.

For seated viewing, the centre of the screen should sit at seated eye level — roughly 100-110 cm (40-43 inches) from the floor for a sofa. For a 65-inch TV that means the bottom edge sits around 60-70 cm up. Mount higher only if you use a tilting mount, e.g. above a fireplace or in a bedroom viewed from the bed.

Fixed mounts sit flattest against the wall and are cheapest. Tilting mounts angle down 5-15 degrees — useful when the TV sits above eye level. Full-motion (articulating) mounts extend and swivel, which suits corner installs or rooms with multiple viewing positions; they cost the most and need the most secure fixing because the load hangs away from the wall.

Not government approval, but many towers require a simple work permit from building management before any contractor drills — book it a day or two ahead and check drilling-hour windows. Villas need no permission unless the community rules say otherwise for external walls.

Only with the right fixings: installers either locate the metal studs, use heavy-duty toggle anchors rated for the load, or fit a plywood backing. For 65-inch-plus TVs on gypsum, a spreader plate or stud fixing is essential — plastic wall plugs alone are the main cause of fallen TVs in UAE flats.