Plastering near you in United Arab Emirates

Plastering is usually priced per square metre or per room. A skim coat over existing sound walls is the cheapest job; full re-plastering (hacking off old plaster and applying new base and finish coats) costs two to three times more, and exterior rendering is priced separately.

Yes, if the substrate is sound — plasterers key the surface and use bonding agents. But blown (hollow-sounding), crumbling, or damp-stained plaster must come off first. A good plasterer taps the walls during the quote to check; be wary of anyone who doesn't.

Rendering is exterior plastering with cement- or silicone-based mixes to protect and finish outside walls; plastering refers to interior walls with gypsum or cement finishes. Many plasterers do both, but exterior render is priced and scheduled differently (weather-dependent).

Skimming is a thin 2-3 mm finish coat applied over existing plaster or plasterboard to give a smooth paintable surface. Full plastering means building up base (browning/bonding) coats plus a finish coat, needed when old plaster is blown, damp-damaged or removed back to brick.

Fine crazing usually means the plaster dried too fast (heat, draughts) and is cosmetic — fill and paint. Straight-line cracks along boards or above doors indicate movement at joints. Wide or recurring cracks are worth a builder's inspection before redecorating.

No — plaster over damp fails within months. The moisture source (rising damp, leaking gutter, condensation) must be fixed first, then damaged plaster cut back and replaced, sometimes with a salt-resistant renovation plaster. Any plasterer who skips the cause is selling you a repeat job.

Heat and dry air pull moisture out before cement plaster cures, causing hairline crazing. Good contractors cure with misting and shade timing, or use ready-mix gypsum plasters indoors. Summer exterior plastering is best done early morning.