Drywall Installation & Repair in Umm Al Quwain

Small patch repairs (nail holes, door-knob dents) typically run the price of a 1-2 hour call-out, while larger holes or water-damaged sections cost more because they need cutting back to studs, new board, taping and up to three coats of joint compound. Whole-wall or ceiling replacement is priced per square metre or square foot.

Yes, almost all do. Small patches are priced as a minimum call-out (often 1-2 hours of labour plus materials) because of travel and return visits for coats. Bundling several small repairs into one visit is the cheapest way to get patches done.

If board has swollen, sagged, or grown mould it must be cut out and replaced — drying alone is not enough. Fix the leak first, cut back at least 30 cm beyond visible damage, and let the cavity dry before new board goes in. Persistent damp needs a moisture-meter check.

Drywall (plasterboard) repair replaces or patches board sheets and finishes the joints with tape and compound. Traditional plastering applies wet plaster coats over masonry or lath. Older homes often have solid plaster walls that need a plasterer, not a drywall contractor.

Hairline cracks at joints and above door frames are usually seasonal movement and are cosmetic. Wide (over 3 mm), diagonal, or recurring cracks, or cracks paired with sticking doors, can indicate settlement — get a builder or structural engineer to look before patching.

Usually AC condensation or a chilled-water pipe leak above the false ceiling — a UAE-specific failure mode. Get the AC contractor to fix insulation or drainage first; replacing board without that means repeat damage within a season.